Chip123 科技應用創新平台

 找回密碼
 申請會員

QQ登錄

只需一步,快速開始

Login

用FB帳號登入

搜索
1 2 3 4
查看: 6218|回復: 2
打印 上一主題 下一主題

有關於LED 驅動IC的操作頻率,請大大幫我解開一個迷思

[複製鏈接]
1#
發表於 2009-11-25 11:28:43 | 顯示全部樓層
可能要先附上 datasheet! 知道的人才可以回答吧!
他有可調的pin嗎?  還是IC 架構上就是如此?
若是IC架構內的,我想是不可調。


剛剛上網查了一下,沒有datasheet只有以下的資訊:
Features

Primary-side feedback eliminates opto-isolators and simplifies design
Adaptive multi-mode PWM/PFM control improves efficiency
Quasi-resonant operation for highest overall efficiency & low EMI
Direct drive of low-cost BJT switch
Dynamic BJT base current control
Very tight constant voltage and constant current regulation with primary-side feedback
Complies with EPA 2.0 no load power consumption and average efficiency regulations
Low start-up current (10 μA typical)
Built-in soft start
Built-in short circuit protection and output overvoltage protection
Built-in current sense resistor short protection
No audible noise over entire operation range
Application

Low power AC/DC adapter/chargers for cell phones, PDAs and digital still cameras
Low power standby power supply
2#
發表於 2011-5-24 18:31:49 | 顯示全部樓層
每一家設計的都不同,原則上AC/DC部分,IC設計廠商均已經內建,所以比較難以修改。
頻率低 EMI問題比較好解,功率可以操的比較大。
頻率高,外部的transformer可以做的比較小,可以更節省體積。相對的EMI/操作功率/和外部的MOSFET更難去調整,所以這一部份,很難看到超過500KHz的工作頻率,不過未來還是會有希望的,因為 "科技可以創造出無限的可能。"
您需要登錄後才可以回帖 登錄 | 申請會員

本版積分規則

首頁|手機版|Chip123 科技應用創新平台 |新契機國際商機整合股份有限公司

GMT+8, 2024-6-1 02:26 AM , Processed in 0.120515 second(s), 16 queries .

Powered by Discuz! X3.2

© 2001-2013 Comsenz Inc.

快速回復 返回頂部 返回列表